| |
OUTBOARD REEDS
BOYESEN Composite Performance Reeds
Johnson & Evinrude Outboard Motors
2 & 3 Cylinder
V4 thru V8 are HERE
These kits contain all the parts need to replace the reeds in your motor. Outboard manufacturers typically have the reeds riveted in placed, and replacements are usually sold only as (expensive) complete reed blocks. The reeds, besides being much less expensive, offer performance gains when accelerating from a stop. The illustration below shows the typical 2-stage design of Boyesen reeds (this drawing is actually typical of Johnson-Evinrude V6 Loop-charged motors).
Look for the manufacturer and horsepower
on the table below to find your application.
Then, just click the button next to it to add the kit you need to the shopping cart.
BE
SURE and submit
THE MODEL
and SERIAL NUMBER information in the special instructions area of the
order form
so we can verify the application to your specific motor
.
In most cases, due to space, the reed set for 1 reed block is shown, but the kit
always includes all necessary reeds for the entire powerhead.
|
|
| |
Please review our Warranty, Returns & Refunds policies before you place an order.
DISCLAIMER
The information provided on these pages is correct to the best of my knowledge, however the MasterTech makes no warranty, express or implied, regarding the use of, results of, or liability created from, application of this data. This information is disseminated in good faith, however MasterTech assumes NO LIABILITY whatsoever in regard to this service. The information, software, products, and services published on this web site may include inaccuracies or typographical errors. Changes are periodically added to the information herein. Mastertech may make improvements to this site at any time. Parts ordered from this website may or may not be in dealer stock at the time of order. Thank you for reading.
© 1999-2012 MasterTech Marine
Revised
|
|